15067 Autoloader ALE: Trailing edge clamp lock/unlock cylinder error, both sensors activated Platesetter_3244 Trendsetter_400/800 This error is reported if the lock cylinder senors indicate both locked and unlocked at the same time, after an attempt was made to move to the locked position. A timeout of te_ulock_delay is allowed and the error is only reported if the sensors are enabled. Check that TEC magnetic clamps are not damaged (even slightly) in the region of keyholes, this may prevent the lock mushrooms from moving to the lock position. Damage or mis aligned TEC magnetic clamps. Sensors, or sensor wiring, or sensor alignment. TEC backbone is not going low enough (close enough to the drum). Check TEC backbone rod end adjustment procedure. ../nvs/al_cal_ntl.xmlNVS: al ntl ../nvs/aldly_cal_teul.xmlNVS: aldly teul ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:50 2008 PST